3/4" AH Finisher Bottom Bowl Gouge
This Gouge is sold without a bolster. If you would like a bolster, please see 3/4” AH Finisher Bottom Bowl Gouge with Bolster.
This 3/4" diameter bottom bowl gouge is made from M2 steel. It is 15” long, rather than the standard 12” long gouges to allow for deeper bowl turning. It has a short flute in order to minimize vibration when a significant amount of the tool is hanging off of the tool rest while working on larger pieces.
It cuts across the inside of the bottom of a bowl or across the face of a platter.
This tool has a small U-shaped flute. The wings are swept back by about 5 degrees, and it has approximately a 50 degree bevel angle.
It is sold un-handled. I recommend using this with the 3/4" bolster, and the 23" handle. You may choose to go with the 30" handle if you're working on particularly deep pieces.
Proudly made in USA. Designed by Ashley Harwood. This design is Patent Pending
This Gouge is sold without a bolster. If you would like a bolster, please see 3/4” AH Finisher Bottom Bowl Gouge with Bolster.
This 3/4" diameter bottom bowl gouge is made from M2 steel. It is 15” long, rather than the standard 12” long gouges to allow for deeper bowl turning. It has a short flute in order to minimize vibration when a significant amount of the tool is hanging off of the tool rest while working on larger pieces.
It cuts across the inside of the bottom of a bowl or across the face of a platter.
This tool has a small U-shaped flute. The wings are swept back by about 5 degrees, and it has approximately a 50 degree bevel angle.
It is sold un-handled. I recommend using this with the 3/4" bolster, and the 23" handle. You may choose to go with the 30" handle if you're working on particularly deep pieces.
Proudly made in USA. Designed by Ashley Harwood. This design is Patent Pending
This Gouge is sold without a bolster. If you would like a bolster, please see 3/4” AH Finisher Bottom Bowl Gouge with Bolster.
This 3/4" diameter bottom bowl gouge is made from M2 steel. It is 15” long, rather than the standard 12” long gouges to allow for deeper bowl turning. It has a short flute in order to minimize vibration when a significant amount of the tool is hanging off of the tool rest while working on larger pieces.
It cuts across the inside of the bottom of a bowl or across the face of a platter.
This tool has a small U-shaped flute. The wings are swept back by about 5 degrees, and it has approximately a 50 degree bevel angle.
It is sold un-handled. I recommend using this with the 3/4" bolster, and the 23" handle. You may choose to go with the 30" handle if you're working on particularly deep pieces.
Proudly made in USA. Designed by Ashley Harwood. This design is Patent Pending